HANTU 5 Zoll 210mm Kohlefaser Rahmen Satz 4mm Arm mit 3D gedruckte Teile für RC FPV Racing Drone
Ein Teil der Rezension wurde automatisch übersetzt.
A battery strap is not included even though the description says one is. The 3D printed pieces look to be printed out of some bad PLA and snap pretty easily. This frame is not the same size as the Mode 2 Ghost frame so 3D pieces printed for either frame will not fit the other. The Ghost uses lock nuts below each of the spacers, this frame does not. The screws go through the lower plate, arms, and directly to the spacers. The arms were not all cut the same direction from the sheet of carbon fiber. The frame does look good. There is plenty of room inside even for first time builders. If you use 2 battery straps, which should fit, your battery will have a very hard time coming out during crashes. 30.5x30.5mm and 20x20mm flight boards are supported. Here is a link to 3D printable pieces that work on this frame: https://www.thingiverse.com/thing:2816953
Рама приходит в коробке. Вырезана хорошо. Толщина пластин соответствует заявленным. Есть запасные винты. Есть Два минуса- вес 59гр(заявленно 55гр) и ремешка нет. Но это не портит впечатления от покупки. Рама нравится.